This adds a tip to the command section about using two hyphens before a
command to signal that no swaymsg options will follow to allow for sway
commands with leading hyphens.
This new option forces pretty (non-raw/non-JSON) output. By default, when
not using a tty, swaymsg outputs using the "raw" format. This makes it
impossible to, for example, pipe the pretty output to a pager such as
`less` since piping does not use a tty.
The new -p/--pretty option gives the user explicit control over the output
format while retaining the default tty-dependent behavior.
Signed-off-by: Peter Grayson <pete@jpgrayson.net>
This add `sway-ipc.7.scd` that documents the IPC protocol.
This also increased the minimum scdoc version from 1.8.1 to 1.9.0 to
allow for table cells to be continued on the following line
In `i3 4.16`, `i3-msg` can be used with the message type `subscribe`
and has the ability to monitor for responses until killed. This adds
support for both to swaymsg.
If the JSON array of event types is malformed or contains an invalid
event, sway will send a response with `success` set to `false`. If
swaymsg sees this, it will not display the failure and exit.
If the `subscribe` event is successful, swaymsg will wait for the first
response and display that instead of the success message. If
`-m/--monitor` is given, swaymsg will continue monitor for responses
until killed or a malformed response is received.
For the `subscribe` event, the responses will always be printed as JSON.
If `-r/--raw` is given, the JSON will not be pretty printed, which may
be preferred when monitoring due to there being multiple responses.
Example: `swaymsg -t SUBSCRIBE -m "['window']"`
Jonas Große Sundrup
Érico Rolim
Mark Stosberg
Campbell Vertesi
Jason Nader
Martin Michlmayr
Brian Ashworth
Peter Grayson
madblobfish
Ian Fan
emersion
Drew DeVault